A customer was having concerns about two gearboxes on a stone saw,they asked if we could inspect them for faults and eliminate them from...

We can supply and fit refurbished motors at a fraction of the cost of brand new.

New slide rails and linear bearings fitted on this saw, the old rails and bearings were worn and rumbling along causing accuracy problems.

This edge polisher needed some repairs after a recent inspection, we changed the gearbox oil, drum bearings at both ends and a pneumatic...

We like a nice new and clean machine, this Comandulli edge polisher was due it's first service and inspection, we had it back in...

In an earlier post we reported on a saw blade carriage and guard that was beyond repair, we contacted manufacturer and was able to obtain...

A customer wanted us to repair their saw blade assembly and guard, but as you can see, on inspection the amount of wear and damage was...

Second hand Speedy install for a customer, on site we levelled the machine bed, modified the guarding, connected up, checked oil and...

Video of refurbished pneumatic ram.

Pneumatic ram for a granite polisher was leaking air and not operating correctly, strip down, clean parts, fit new seals, paint and...

The bespoke pin puller was put to use extracting some pin from a fiberglass processing machine, all four pins were removed successfully.

A customer required some bent pins removing from a fiberglass sheet maker, the pins were to prop the machine open when cleaning and...

A customer called having lost up and down movement on his stone saw cutting blade, on inspection the coupling from drive motor to screw...

Burnt out wiring on a diesel powered water pump, fault found,diagnosed and repaired, pump was put back into service, another happy...

Invited to repair/service a granite polishing machine at customer premises, full day of spanner work and one happy customer, ready for...